User's Manual

PINEAPPLE TECHNOLOGY, INC.
UT X1K W-A Ope rating a nd Se rvic e Ma nua l
15. Slowly increase the output level adjustment while watching the RF Output level on the ADP1000.
When the output gets up to 50% indicated power stop the adjustments.
16. Using the ADP1000 refl ected power indication check the LOAD refl ected power. This should be
less that 5% refl ected.
17. Return to the PA current readings on the ADP1000 to verify that all the currents are approximately
the same.
18. With successful performance through step 17, the transmitter output power can be increased using
the output level adjustment on the modulator to achieve 100%. The aural power can be added at this
time not exceeding 10% of output p-sync power as indicated on the ADP1000.
IV — TRANSM I TTER TURN -ON PROCEDURE
Page 7