User's Manual

PINEAPPLE TECHNOLOGY, INC. V.5 . ETHERNET WEB PAGE CONTROL AND MONITORING
DTXPRO-10U OPERATING AND SERVICE MANUAL
THE INFORMATION PROVIDED HEREIN IS PINEAPPLE TECHNOLOGY INCORPORATED PROPRIETARY INFORMATION AND
CANNOT BE COPIED OR DISTRIBUTED WITHOUT PRIOR AUTHORIZATION
29
V.5 DXDPRO-10U ETHERNET WEB PAGE CONTROL AND MONITORING
B. ETHERNET WEB PAGE SETUP
General Introduction
The web service control interface allows monitoring of status as well as configuration of the operational
parameters of the device subject to the log-in status for the user (observer, operator or administrator). The user
interface (web browser display) applies a user friendly concept where the general navigation between individual
sub menus is based on a block oriented representation of the controlled device. The specific control for a certain
function is therefore easily accessed by ‘dragging’ the functional block of interest into the configuration section of
the display.
The web service interface is equally useful for controlling the PT2000 Terrestrial Gateway product in a
configuration with a direct connection (Ethernet patch cable) between the PT2000 Terrestrial Gateway product
and the PC as well as in the typical operational environment where multiple products are accessible from the PC
across a shared network.
Document structure and scope
This instruction manual is divided into three main sections:
• Electrical interface and IP address configuration;
• Operation principle for the Web service interface; and,
• Software update over Ethernet.
The present document describes the operation from a generic viewpoint and it does therefore not address in
detail functions or settings applicable to a specific member of the Terrestrial Gateway product family.
C. IP ADDRESS CONFIGURATI0N
IP address settings for the PT2000 Terrestrial Gateway product can be carried out in several different ways:
a) Hardware preset to default status
b) Configuration over Ethernet (the current address setting must be known and that the PC used for the
configuration must be configured with a compatible address)
1. IP Address Preset
• IP address : 192.168.168.168
• Network Mask: 255.255.0.0