User Manual

1002908-EN-02
PSEN op Protective Column/1
Operating Manual
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany 7
Telephone: [phone], Telefax: [phone], E-Mail: [e-mail] Original document
Levelling and angular adjustment of the plates
The grooves on the base plate are used to define the required angle
position. Tighten the slot holes on the bottom plate with the screws
M10 on the floor (not entirely). Slightly loosen the counter nuts on
the top plate and align unevenness using the spirit level. Then fix
the screws M10 completely. Finally, check again whether the
protective column is straight, readjust if necessary and tighten the
counter nuts again (Fig. 6).
Fig. 6
Slot holes for floor
screws
Spirit level