Datasheet

PNOZmulti 2 products
Fieldbus modules
PNOZ m ES EtherNet/IP
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: [phone], Telefax: [phone], E-Mail: [e-mail]
2015-11
868
} Use of the DHCP Server is enabled
DHCP is automatically enabled on a new module. In this case the IP address is taken
from the DHCP Server, if the DIP switch is set to 0. The module waits to receive an ad-
dress from a DHCP Server.
} If a fixed IP address has been assigned via the web server or by the EtherNet/IP scan-
ner, then this will be used. The DIP switch must be set to zero for this purpose.
} Setting via the DIP switch
The IP address that is set at the DIP switch is used. DHCP is therefore disabled.
Set the DIP switch to a value between 1 – 254.
} Enable DHCP via DIP switch
If you set the DIP switch to 255, then DHCP will always be used, irrespective of the
configuration in the web server.
Example: DIP switch: 00010100 (20 decimal)
(MSB) (LSB)
1 2 3 4 5 6 7 8
ON
Fig.: DIP switch setting: 20 (decimal) as the value for the last byte of the IP address
DIP switch
"IP address"
Meaning
Example:
IP address 020
D
OFF ON
1 0 128
D
2 0 64
D
3 0 32
D
4 0 16
D
5 0 8
D
6 0 4
D
7 0 2
D
8 0 1
D
DIP switch IP address