Datasheet

PNOZmulti 2 products
Fieldbus modules
PNOZ m ES EtherNet/IP
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: [phone], Telefax: [phone], E-Mail: [e-mail]
2015-11
865
Output range
The outputs are defined in the PNOZmulti Configurator. Each output that is used is given a
number there, e.g. O0, O5... .
The status of output O0 is stored in bit 0 of byte 0; the status of output O5 is stored in bit 5
of byte 0 etc.
Virtual inputs
PNOZmulti Configurator
O0 … O7 O8 … O15 O16 …
O23
... O120…
O127
EtherNet/IP Byte 0:
Bit 0 … 7
Byte 1:
Bit 0 … 7
Byte 2:
Bit 0 … 7
... Byte 15:
Bit 0 … 7
} Bit 0 … 4: Status of LEDs on the PNOZmulti 2
Bit 0: OFAULT
Bit 1: IFAULT
Bit 2: FAULT
Bit 3: DIAG
Bit 4: RUN
} Data exchange is displayed in Bit 5.
} Polling the payload data: 2 Bytes with the table number and segment number are sent
by the Master for access to the payload data table (15 Bytes are returned to the Mas-
ter).
Detailed information on data exchange is available in the document "Communication Inter-
faces PNOZmulti 2" in the section entitled "Fieldbus modules".
Block diagram
Base unit
Ethernet/IP
24V 0V
24V 0V FE