Datasheet

PNOZmulti 2 products
Base units
PNOZ m B0
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: [phone], Telefax: [phone], E-Mail: [e-mail]
2015-11
670
Commissioning the control system
Procedure:
} Wire the inputs and outputs on the base unit in accordance with the circuit diagram.
} Connect the supply voltage:
– Supply voltage for the control system:
– Terminal A1: + 24VDC
– Terminal A2: 0 V
– Supply voltage for the semiconductor outputs:
– 24 V terminal: + 24VDC
– 0V terminal: 0 V
Please note: The supply voltage for the semiconductor outputs must always be present,
even if you are not using the semiconductor outputs.
When the voltages are fed separately using two power supplies, the supply voltage for the
control system and the supply voltage for the semiconductor outputs are galvanically isol-
ated.
Connection
Supply voltage
Separate power supplies for the
supply voltage to the control sys-
tem and the supply voltage to the
semiconductor outputs
+24 V DC
0 V DC
Supply
voltage infeed
for the control
system
Supply
voltage infeed for
the semiconductor
outputs
0 V DC
+24 V DC
=
~
NL1
=
~
NL1
A1
A2
24V
0V