Datasheet

PNOZmulti products
Fieldbus modules
PNOZ mc6p/mc6.1p
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: [phone], Telefax: [phone], E-Mail: [e-mail]
2015-11
443
Front view
CANopen
PNOZ mc6p
PWR
ERR
x1
x10
X1
RUN
DR
Key
} X1: CANopen interface (male 9-pin D-Sub connector)
} LED:
– Power
– Run
– Error
Function description
Operation
The virtual inputs and outputs that are to be transferred via CANopen are selected and con-
figured in the PNOZmulti Configurator. The base unit and the expansion module PNOZ
mc6p/mc6.1p are connected via a jumper. The station address and the transmission rate
are set using rotary switches. The fieldbus module is also supplied with voltage via this
jumper. After the supply voltage is switched on or the PNOZmulti control system is reset,
the expansion module PNOZ mc6p/mc6.1p is configured and started automatically.
LEDs indicate the status of the expansion module on CANopen.
The configuration is described in detail in the PNOZmulti Configurator's online help.