Datasheet

PNOZmulti products
Speed monitors
PNOZ ms2p HTL
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: [phone], Telefax: [phone], E-Mail: [e-mail]
2015-11
309
Safe monitoring with "reduced speed" operating mode
Configuration in the PNOZmulti Configurator
} Standstill: depending on requirement
} Speed n1: reduced speed, depending on requirement
} Speed n2: greater than the maximum permitted speed.
If the "Overspeed" output (see red marking) = "0", either the maximum permitted speed has
been exceeded or the speed monitor has recognised a fault.
"Overspeed" output = "0" must lead to the shutdown of the relevant axis, irrespective of
whether the "reduced speed" operating mode is active.