Datasheet

Relays for functional safety
Safety relays PNOZsigma
PNOZ s50
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: [phone], Telefax: [phone], E-Mail: [e-mail]
2016-09
912
Display menu and configuration
The menu settings are made on the unit's display via a rotary knob. You have the option to
make the settings on the knob by hand or with a screwdriver. If you make the settings with
a screwdriver, the knob can remain within the unit.
Operate rotary knob
[1]
[2]
Pull out knob (A):
} until it locks into position
} Release knob (B) and push it back into the unit:
– Press the bar on the side of the knob [1] towards the centre of the knob. This re-
leases the knob.
– Press the knob downwards [2] while keeping the bar pressed in
Configure device
The settings are made via the rotary knob, as follows:
Press the knob
} Confirm selection/setting
} Switch to menu
Rotate knob
} Select menu level
} Set the parameter/numeric value
The display is backlit. It is
} switched on by turning or pressing the rotary knob.
} switched off if the rotary knob has not been operated for 30 seconds.
Password protection
The configuration is password-protected.
} Parameters can only be changed once a password has been entered.
} Factory setting for the password: 000000
} The pasword consists of 6 figures in the range 000000 … 999999.
} The password can be changed at any time in the menu.