User Manual

IM_100.CCF.20170801-EN T1
14
Important
Safety I
nstructions
1.6 Battery charger and operating conditions
For a safe use of your Pilotfly T1 battery charger pay attention, that …

you make sure that the specified voltage data on the rating label are fitting to the specification of the
power socket.

you never grasp the power plug with wet hands. If you want to pull the power plug out of the power
socket, you always pull directly at the power plug. Never pull at the cable, it could be damaged.
Furthermore, never transport the device at the cable.

the cable is not modified, jammed, folded, charged by heavy objects, crossed over by vehicle, comes
into touch with heat sources or sharp edges. In addition, it mustn't become a stumbling trap.

you regularly check the device, the accessories and the cables for damages. If you should notice
damages, you may not continue to use the device any more. For repairs send it only to the Pilotfly-
Service.

you immediately switch off the device, if you notice smoke, unusual noises or smells. Do not continue
using it any more before a check was performed by an expert. Send it only to the Pilotfly-Service.

you switch the device off and you unplug the power plug from the power socket before you clean or
service it.

you always pull the power plug out of the power socket at a thunderstorm. At a thunderstorm, the
equipment which is attached at the power grid can be damaged.

you use the battery charger only indoors and dry surroundings.

you do not cover the battery charger to avoid a damage by not allowed temperature rise.

the power socket is near by the connected device, so that you easily have access to separate the
device from the power grid in case of failure.