User Manual

CHAPTER 4. REMOTE SWITCH FUNCTIONS 37
Pressing and holding undo or pressing both Reverse and Undo resets
the sample rate to the initial recording sample rate.
The default Interval selection is one octave, enabling Reverse and
Undo to double-speed and half-speed recorded audio respectively.
This interval can be changed using the Remote Mapping Menu, ac-
cessed by pressing the Series Loops switch for 2 seconds. The digit
will flash three horizontal lines and a number to indicate the current
intervallic change. Turn the preset encoder to select a different inter-
val and press down on the Preset Encoder to finalize and exit. The
intervals are displayed as a number and decimal point; each number
represents a corresponding scale degree (2 is a second, 3 is a third,
etc.) while the decimal point indicates whether that interval is flatted.
The Remote Mapping Menu only sets the Interval while in the Varispeed
Remote Control Menu, if you leave the Varispeed Remote Control
Menu the Remote Mapping Menu sets the Expression Pedal assign-
ment as described on page 39.
Display Interval
2. Minor Second
2 Major Second
3. Minor Third
3 Major Third
4 Perfect Fourth
5. Diminished Fifth
5 Perfect Fifth
6. Minor Sixth
6 Major Sixth
7. Minor Seventh
7. Major Seventh
8 Perfect Octave
Caution: Press-and-hold functionality on the Reverse and Undo switches in
this menu prevents actions taking place immediately when pressed. While in
the Varispeed Remote Control Menu, short press actions are executed when
the Reverse and Undo switches are released.