User Manual

CHAPTER 2. ANATOMY AND FUNCTIONS 17
When an external MIDI Clock is used, the Arm LED for the currently
selected Loop will blink at the received tempo.
Stop LED
The Stop LED will glow red when loop audio is stopped.
Clip LED
This red LED between the Loop Volume knobs will indicate when
the input signal is reaching the maximum headroom of the Infinity’s
recording engine and begins to trigger the analog limiter stages. If
the Clip LED is lighting up solid red, reduce the output level of your
instrument until the Clip LED is just beginning to light up at the peaks
in your audio signal.
Multi-Segment Digit
This numeric display tells the user which preset is currently selected
(within the selected bank) and is also used to confirm firmware update
“F”, and to indicate copy in progress “C” and USB active “U” states.
In Varispeed mode (see page 36) a “-” is displayed. It’s height repre-
sents the speed of the sample rate.
Decimal Point
Located to the right of the digit, this LED lights up to indicate that
audio has been recorded to a preset bank. When changes have been
made to a preset but not saved, the decimal point will blink. Once
the changes have been saved, the decimal point will return to solid.