User Manual

CHAPTER 2. ANATOMY AND FUNCTIONS 12
Once Loop 2 is recorded, the Sync is locked to the multiplier you
have selected. It is possible to turn Sync on and off at this point, but
you must delete Loop 2 if you want to switch to a different multiplier
value.
Once Loop 2 is recorded, its length is fixed. However, turning Sync off
after that point allows you to start playback of Loop 2 at any time,
not just at the start of Loop 1. Keeping Sync Multi on means that
Loop 2 will always replay from the start Loop 1.
During recording, whichever loop is armed will automatically close
once you hit the maximum allowable length. Overall recording time
for Loop 1 is dependent on the multiplier value you’ve selected for the
current preset, the size of the memory card you have installed in your
Infinity Looper, and the number of preset slots you have assigned using
the PC or MAC application. See the table on page 52 for maximum
recording times based on these factors.
2.3 Knobs
Master Volume
This knob functions as a stereo output control, determining the output
level of both loop audio and pass-through audio.
When turned fully clockwise, the Master Volume knob provides an
overall boost of approximately 3dB.
Setting it at around 3 o’clock gives you unity gain.