Product Manual

www.piercearrow.us 3
7.5 T KIT
8’ BED 10’ BED 12’ BED
0” 7 T 6.5 T 6 T
12” 7.5 T 7 T 6.5 T
24” - 7.5 T 7 T
36” - - 7.5 T
5 T KIT
8’ BED 10’ BED 12’ BED
0” 4.75 T 3.75 T 3
12” 5 T 4.75 T 3
24” - 5 T 4.75 T
36” - - 5 T
CHOOSING THE LIFT ANGLE
The bed length and overhang length
eect the capacity of your kit. For
example, if you require the maximum
capacity for a 7.5 T kit you must have:
8’ bed with 12” overhang
- or -
10’ bed with 24” overhang
- or -
12’ bed with 36” overhang
Refer to the table to the right for more
informaon.
Before beginning . . .
To reach maximum kit capacity and li a few quesons
must be asked.
1. What is the bed length?
2. How much overhang past the frame can I have?
3. What is the opmal dump angle for my applicaon?
Desired bed height and li capacity are determined by
the placement of the crossmember. Chassis construc-
on may dictate crossmember locaon.
CHOOSING THE
SCISSOR PLACEMENT
Measure from the frame hinge pin
toward the cab. Mark 5’ 8” and 6” 6”.
The scissor assembly crossmember and
frame L bracket can be placed within
this area.
5’ 8” 6’ 6”
12”
OVERHANGOVERHANG
crossmember
frame
scissor assembly
crossmember and
frame L bracket