User Manual

Switch your Pieps Freeride from transmit to
receive mode by pressing 3 times on the “Send-
Search” switch.
SEARCH-MODE / COARSE SEARCH
<<<
press 3x
SEARCH FOR INITIAL DETECTION
Walk quickly over the dened search area in a
pattern corresponding with the recommended search
strip width whilst searching for initial detection.
Given that every standards-compliant avalanche
transceiver transmits only around once per second,
turn your Pieps Freeride slowly in all directions (in
three dimensions). The recommended search strip
width for the Pieps Freeride is 30m.
IMPORTANT! In SEARCH mode work calmly
with full concentration. Avoid hasty movements.
In SEARCH mode no signal is transmitted. In the
event of a second avalanche, hold the “send/
search” switch down for 3 seconds (?) in order to
resume SEND mode.
A rescuer searching for initial
detection
30
15
15
Several rescuers searching for initial
detection
SEARCH FROM INITIAL DETECTION
THROUGH TO FINE SEARCH (COARSE SEARCH)
As soon as the PIEPS Freeride receives signals, the
approximate distance to the victim is shown on
the display:
Symbol for “1 victim” within reception zone.
Symbol for “multiple burial”
In a case of multiple burial, all signals are
processed simultaneously, but only the
strongest signal is shown on the display.
The arrow on the dynamic eld direction
display is 100% full so long as the Pieps
Freeride is aligned with a eld line:
F
i
e
l
d
l
i
n
e
s
1
2
3
1
2
3
15
1530 30