Operation Manual
The optimized multiple burial search is based on a separation of signals via the digital
signal processor (DSP).
MULTIPLE BURIALS
If there are multiple burials, this is clearly indicated by the number of matchstick men.
By default, the PIEPS DSP PRO/DSP SPORT will automatically search for the strongest signal.
MARK without moving away from this point. This signal is now suppressed. Once a signal
has been successfully suppressed, an outline appears around the matchstick man.
The PIEPS DSP PRO/DSP SPORT will automatically search for the next strongest signal.
Now continue the search as described above, and repeat the procedures until all
transmitters are located. If there are no further signals within the receiving range the
display indicates “No Signal”.
(1)
(2)
(3)
(4)
(5)
DEENESFRITCZSKSIRUJP
Number of
possible marks:
Marking is possible within a range
of 5 m to the transmitting beacon.
Marking of a second transmitter is
possible after 3 seconds after marking
these requirements are not provided,
an alert signal sounds by pressing the
button „MARK“ again.
max. 5 transmitters,
3 are indicated on
the display
Mark reset of single suppressed signals: To reset the MARK function for single signals, press
the button MARK for 3 seconds.
Mark reset of all suppressed signals: To reset the MARK function switch your PIEPS DSP
PRO/DSP SPORT into SEND-mode and then back to SEARCH-mode. With the PIEPS DSP PRO
you also have the possibility to reset MARK with the following described SCAN-function. All
information from previously suppressed signals is now reset and you can start with MARK again.
Old device mode: Older analog transceivers are transmitting a weak continuous signal
additional to the digital pulse signal that can have an impact on the digital signal separation. In
these transmitters keep a distance of more than 1 m.
signal with continuous carrier
signal without continuous carrier
IMPORTANT!
The MARK function is subject to physical and technical limitations. This applies to all
transceivers with MARK function! In practice, one might observe performance-reducing limitations which
get intensied by overlapping signals. More information can be found on www.pieps.com.
MULTIPLE BURIALS
PIEPS provides with the PIEPS SAFETY SYSTEM (digital PIEPS beacon and electronic probe
PIEPS iPROBE) a technical 100% solution for multiple burials. By using a digital PIEPS
beacon in combination with the PIEPS iPROBE or iPROBE ONE someone can solve a multiple
burial without any performance-reducing limitations! See also chapter „iPROBE Support“.
06/15 ||
06/15 3332