Operation Manual
BEACON-CHECK | GROUP-CHECK
Activation of group-check-function:
1. Turn on your PIEPS DSP PRO/DSP SPORT
(Position SEND).
2. Wait until „CH“ appears on the display
(CH = CHECK).
3. Press and continue to hold the
MARK button.
The group-check-function is active as long
as the MARK button is pressed. Release
the MARK button to exit the group-check-
function. After a countdown of three seconds,
your DSP PRO/SPORT automatically turns into
the SEND mode. During the countdown, the
group-check-function can be reactivated.
The maximum range in group-check-mode is
one meter!
Conduct the „big“ beacon-check as follows:
(1) Receiving control
Group leader –SEND-mode: Device is sending?
All others – SEARCH-mode: Devices are receiving?
(2) Transmission control
Group leader – group-check-mode: Device is receiving?
All others –SEND-mode: Devices are sending?
3 second countdown
1
2
Device is not
sending or
distance is too
large (> 1 m).
Device is
sending.
Frequency not
within the
acceptable
range.
TIP! The receive control can be combined
with a range test in long distance.
DEENESFRITCZSKSIRUJP
The Intelligent Transmitter – Maximum support in SEND-mode
In SEND-mode there are functions working in the background of PIEPS DSP PRO/DSP SPORT
Auto-Antenna-Switch
maximum range to the receiving beacon!
iPROBE-Support
Beacons with iPROBE Support* will be automatically deactivated when probing with the
electronic probe PIEPS iPROBE. Signal overlap is eliminated and the next strongest signal
is automatically shown on the display of the receiving beacon. The PIEPS iPROBE supports
maximal in the case of a multiple burial. See also chapter „Multiple Burials“.
The PIEPS iPROBE Support gives the best solution for multiple burial situations!
*Beacons with iPROBE Support: PIEPS DSP PRO, PIEPS DSP SPORT, PIEPS DSP (with Software
version 5.0 or greater), PIEPS DSP TOUR, PIEPS FREERIDE
More information can be found on www.pieps.com.
SEND-MODE
Press the main switch lock and push the main switch to the
“SEND“ position. The display indicates the SEND-symbol,
the remaining battery capacity, and the transmitting antenna.
transmitter bit timing.
When you are on a tour, make sure the “SEND“-mode is selected
throughout. The PIEPS DSP PRO/DSP SPORT will transmit a
all other avalanche beacons (according EN300718).
06/15 ||
06/15 2726