User manual

DO189-1

TA133-User’s Guide

Handling

Handle with care especially when fitted with the extra thin and sharp spring contact tip to avoid

any injury. Note that the probe cable is a sensitive part of the probe. Do not damage through

excessive bending or pulling. Avoid mechanical shock to this product in general to guarantee

accurate performance and protection.

Maintenance

Cleaning

To clean the exterior of the probe use a soft cloth moistened with either distilled water or isopropyl alcohol.

Before use allow the probe to dry completely.

Changing the Probe Tip

To change the probe tip use pliers to grip and pull it carefully straight out of its contact socket, along the

axis of the probe. Do not grip the white plastic insulator or the housing with pliers, because the tip could be

squeezed and made impossible to remove. The probe could be damaged.

If the probe tip is removed, the new tip can be inserted with pliers into the contact socket, along the axis

of the probe. In order to insert the probe tip completely into the housing, press the probe tip carefully against

a hard

surface.

Use pliers to grip and pull the probe tip carefully out

of its contact socket.

Do not grip the white plastic insulator or the probe

housing with pliers.