User manual

PicoScope 6 User's Guide 145

7.9.2.2

Digital trigger dialog

Location:

Advanced triggering dialog > Digital and Logic buttons

Purpose:

sets up triggering on digital inputs

Applicability:

MSO devices only

Pattern table

Lists all available inputs as selected in the Digital Setup dialog. Each one can be

monitored for a low or high level or a rising or falling edge, or ignored. Any number of

levels can be specified, but no more than one transition (edge).

D7 = X (don't care)

D7 = 0 (low level)

D7 = 1 (high level)

D7 = R (rising edge)

D7 = F (falling edge)

Pattern summary

This section contains the same settings as the pattern table but in a more concise

format.

The numerical format to use for this section: Binary

or Hex(adecimal).

The complete triggering pattern and transition. In

Binary mode the bits are labelled as follows:

X = don't care

0 = binary 0

1 = binary 1

R = rising edge

F = falling edge