User manual

Menus78

Clock Channel. Which channel is connected to the SCL signal.

Clock Threshold. The threshold voltage to use for the SCL signal.

Data Threshold. The threshold voltage to use for the SDA signal.

Settings. Opens the I²C Settings dialog .

RS232/UART settings

Threshold. A voltage halfway between the high and low logic levels. If you are not

sure, set this to halfway between the maximum and minimum voltages that you

see on the waveform.

Baud Rate. The speed of data transmission in symbols per second. Set this to

match the speed of the data bus.

Bit Definitions. Opens the Bit Definitions dialog for setting up RS232 format

parameters.

SPI settings

Clock Channel. Which channel is connected to the clock signal (SCLK or CLK).

Clock Threshold. The threshold voltage to use for the clock signal.

Data Threshold. The threshold voltage to use for the data signal (SDI, DI, SI,

SDO, DO or SO).

CS Channel. Which channel to use for the chip select (CS, SS or STE) signal, if

present.

CS Threshold. The threshold voltage to use for the chip select signal.

Settings. Opens the Settings dialog .

LIN settings

Threshold. The threshold voltage used to distinguish high and low logic levels.

Settings. Opens the LIN Settings dialog .

181

182

177