User manual

PicoScope 6 User's Guide 195
Copyright © 2007-2012 Pico Technology Ltd. All rights reserved. psw.en
RGB LED on USB DrDAQ 118
Rise time
threshold 47
Rising edge button 137
RPM 26, 100
RS232
protocol 181
settings 81
RS232/UART settings 77
Rulers 13, 17, 19
definition 188
deleting 24, 25
handles 13, 17, 19
legend 26
lock button 26
time 13, 19
voltage 13, 17, 19
Runt pulse trigger 140
S
Sampling preferences 93
Sampling rate 120
Save As 35
dialog 36
Save file 35
Save on trigger 84, 163
Scaling 9, 153
button 110
Scaling Method dialog 54
Scope device 188
Scope measurements
AC volts 168
Cycle time 168
DC volts 168
Duty cycle 168
Fall time 168
Falling rate 168
Frequency 168
High pulse width 168
Low pulse width 168
Maximum 168
Minimum 168
Peak to peak 168
Rise time 168
Rising rate 168
Scope mode 10
button 120
Scope view 11, 13
Scrolling 153
Selection tool, normal 146
Send channel to back 110
Serial decoding 30, 49
data window 79
dialog 76
link file 79
Serial number
of oscilloscope 101
Serial protocols 175
Settings
saving 35
Settings dialog 82
Signal difference, how to measure 150
Signal generator
button 127
dialog 127
USB DrDAQ 129
Waveform types 171
Signal generator sweep mode 183
Signal rulers 13, 17, 19, 24
Sinx(x)/x preferences 93
Slow sampling transition 93
Smoothing 93
Software version 1
Sound file 84
Space bar 136
Spectrum measurements
Amplitude at peak 169
Frequency at peak 169
Intermodulation Distortion (IMD) 169
Signal to Noise Ratio (SNR) 169
Spurious-free Dynamic Range (SFDR) 169
Total Harmonic Distortion (THD) 169
Total Harmonic Distortion plus Noise (THD+N)
169
Total power 169
Spectrum mode 10
button 120
enabling and disabling 100
Spectrum options
bins 122
dialog 122
display mode 122
scale 122
Spectrum view 11, 19
how to set up 155
SPI Bus protocol 182
SPI settings 77, 82
Spreadsheet, exporting to 36
Spurious edges, finding 140
Standard deviation 21, 188
Start/Stop toolbar 100, 136
Startup Settings menu 41
State trigger 143