User manual
Table Of Contents
- Introduction
- Getting started
- Writing your own software
- About the driver
- Installing the driver
- Connecting the logger
- Capture modes
- USB DrDAQ Routines
- Summary
- UsbDrDaqOpenUnit
- UsbDrDaqCloseUnit
- UsbDrDaqGetUnitInfo
- UsbDrDaqRun
- UsbDrDaqReady
- UsbDrDaqStop
- UsbDrDaqSetInterval
- UsbDrDaqSetTrigger
- UsbDrDaqGetValues
- UsbDrDaqGetTriggerTimeOffsetNs
- UsbDrDaqGetSingle
- UsbDrDaqOpenUnitAsync
- UsbDrDaqOpenUnitProgress
- UsbDrDaqGetScalings
- UsbDrDaqSetScalings
- UsbDrDaqSetSigGenBuiltIn
- UsbDrDaqSetSigGenArbitrary
- UsbDrDaqStopSigGen
- UsbDrDaqSetDO
- UsbDrDaqSetPWM
- UsbDrDaqGetInput
- UsbDrDaqStartPulseCount
- UsbDrDaqGetPulseCount
- UsbDrDaqEnableRGBLED
- UsbDrDaqSetRGBLED
- UsbDrDaqGetChannelInfo
- PICO_STATUS values
- Programming support
- Glossary
USB DrDAQ Programmer's Guide 41
Copyright © 2010-2011 Pico Technology Ltd. All rights reserved. usbdrdaqpg.en
UsbDrDaqStartStreaming.vi – starts the device streaming data after the USB
DrDAQ has been set up using UsbDrDaqSettings.vi. The "number of values" input
is used by the driver to create its buffer. Once this VI has been called, values can be
obtained from the driver using UsbDrDaqGetStreamingData.vi.