USB TC-08 Single-Channel Terminal Board User’s Guide
USB TC-08 Single-Channel Terminal Board User’s Guide 1 Pico Technology Safety notices You MUST observe the following safety notices to prevent damage to equipment and personal injury. DO NOT do not connect the terminal board to any voltage source exceeding the maximum input range printed on the board. DO NOT connect the terminal board to a mains (line voltage) electrical supply. The high voltage will damage or destroy the equipment and may cause serious or fatal injury. 2 Overview 2.
Pico Technology 3 USB TC-08 Single-Channel Terminal Board User’s Guide Measuring voltages and currents 1) 2) Connect the negative side of your circuit to the COM terminal. Connect the positive side of your circuit to the “5 V”, “500 mV” or “50 mV” terminal depending on the voltage range of the signal. For a 4-20 mA loop signal, use the “5 V” input. 3) For a 4-20 mA loop signal, set the switch to “ON”. For a voltage signal, set the switch to “OFF”. 4) Plug the terminal board into the USB TC-08.
USB TC-08 Single-Channel Terminal Board User’s Guide Pico Technology Issue history: 1) 14.9.09. New. Pico Technology James House Colmworth Business Park ST. NEOTS Cambridgeshire PE19 8YP United Kingdom Tel: +44 1480 396395 Fax: +44 1480 396296 www.picotech.com Copyright © 2009 Pico Technology Ltd. All rights reserved.
