Manualshelf

User manual

ManualsBrandsPICO ManualsLaboratory Test EquipmentPC scope module Scope2208A 200 MHz 2-channel 500 null 48 null 8 Bit Digital storage (DSO), Function generator,
12345678910
Introduction6
Copyright © 2014 Pico Technology Limited. All rights reserved.ps2200a.en r2
1.1.5
Care of the product
The oscilloscope and its accessories contain no user-serviceable parts. Repair and
servicing require specialized test equipment and must only be performed by Pico
Technology or an approved service provider. There may be a charge for these services
unless covered by the Pico five year warranty.
WARNING
To prevent injury or death, do not use the instrument if it appears to be
damaged in any way, and stop use immediately if you are concerned by any
abnormal operations.
WARNING
When cleaning the oscilloscope, use a soft cloth and a solution of mild soap or
detergent in water. To prevent electric shock, do not allow liquids to enter the
casing, as this will cause damage to the electronics or insulation inside.
CAUTION
Do not tamper with or disassemble the oscilloscope, connectors or
accessories. Internal damage will affect performance.
1.2
Conformance
1.2.1
FCC notice
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his or her own
expense.
For safety and maintenance information see the safety warning.
1.2.2
CE notice
The product meets the intent of the EMC directive 2004/108/EC and has been
tested to EN61326-1:2006 Class A Emissions and Basic Immunity.
The product also meets the intent of the Low Voltage Directive and has been
designed to meet BS EN 61010-1:2010 Safety requirements for electrical
equipment for measurement, control, and laboratory use.