Datasheet

PicoScope
®
5000D Series oscilloscopes
PicoScope 5000D Series
Technical Specications
PicoScope 5242D
and 5242D MSO
2-channel, 60 MHz
PicoScope 5243D
and 5243D MSO
2-channel, 100 MHz
PicoScope 5244D
and 5244D MSO
2-channel, 200 MHz
PicoScope 5442D
and 5442D MSO
4-channel, 60 MHz
PicoScope 5443D
and 5443D MSO
4-channel, 100 MHz
PicoScope 5444D
and 5444D MSO
4-channel, 200 MHz
Output frequency range
DC to 20 MHz (<2 dB into 50 Ω) sine
Up to 10 MHz all other waveforms
Standard signal frequency 0.025 Hz to 20 MHz (< 1.5 dB into 50 Ω)
Sweep modes Up, down, dual with selectable start / stop frequencies and increments
Triggering
Can trigger a counted number of waveform cycles or frequency sweeps (from 1 to 4 billion) from the scope trigger, external trigger or from
software. Can also use the external trigger to gate the signal generator output.
Output frequency accuracy Oscilloscope timebase accuracy ± output frequency resolution
Output frequency resolution < 25 mHz (0.025 Hz)
Output voltage range ±2 V
Output voltage adjustments Signal amplitude and offset adjustable in approx 0.3 mV steps within overall ±2 V range
Amplitude atness < 2 dB to 20 MHz, typical
DC accuracy ±1% of full scale
SFDR > 70 dB, 10 kHz full scale sine wave
Output resistance 50 Ω ±2%
Connector type BNC(f)
Overvoltage protection ±20 V
Arbitrary waveform generator
AWG update rate 200 MHz
AWG buffer size 32 kS
AWG resolution 14 bits (output step size approx 0.25 mV)
AWG bandwidth > 20 MHz
AWG rise time (10% to 90%) <10 ns (50 Ω load)
Additional AWG specications including sweep modes, triggering, frequency accuracy and resolution, voltage range, DC accuracy and output characteristics are as the function
generator.
Probe compensation pin
Output characteristics 600 Ω
Output frequency 1 kHz
Output level 3 V peak to peak, typical
Overvoltage protection 10 V
DRAFT
DRAFT