User Manual

Introduction6
Copyright © 2018 Pico Technology Ltd. All rights reserved.ps5000d.en r1
2.1.6 Environment
WARNING
To prevent injury or death, do not use in wet or damp conditions, or around explosive gas or vapor.
CAUTION
To prevent damage, always use and store your oscilloscope in appropriate environments.
Storage
Operating
Temperature
–20 °C to +60 °C
0 °C to +40 °C
(+15 °C to +30 °C for quoted accuracy*)
Humidity
5% to 95% RH
(non-condensing)
5% to 80% RH
(non-condensing)
Altitude
2000 m (maximum)
Pollution degree
2 (maximum)
*One hour warm-up for quoted accuracy
2.1.7 Care of the instrument
The product contains no user-serviceable parts. Repair, servicing and calibration require specialized test
equipment and must only be performed by Pico Technology or an approved service provider. There may be a
charge for these services unless covered by the Pico five year warranty.
WARNING
To prevent injury or death, do not use the product if it appears to be damaged in any way, and stop
use immediately if you are concerned by any abnormal operations.
WARNING
To prevent electric shock, do not tamper with or disassemble the oscilloscope, case parts,
connectors or accessories.
WARNING
When cleaning the product, use a soft cloth and a solution of mild soap or detergent in water. To
prevent electric shock, do not allow liquids to enter the oscilloscope casing, as this will compromise
the electronics or insulation inside.
2.2 Conformance
2.2.1 FCC notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 Subpart B of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference which the user will be required to correct at their own expense.