Datasheet

PicoScope
®
5000D Series oscilloscopes
PicoScope 5000D Series
Technical Specications
PicoScope 5242D
and 5242D MSO
2-channel, 60 MHz
PicoScope 5442D
and 5442D MSO
4-channel, 60 MHz
PicoScope 5243D
and 5243D MSO
2-channel, 100 MHz
PicoScope 5443D
and 5443D MSO
4-channel, 100 MHz
PicoScope 5244D
and 5244D MSO
2-channel, 200 MHz
PicoScope 5444D
and 5444D MSO
4-channel, 200 MHz
Trigger sensitivity (analog
channels, ETS)
At full bandwidth: typical 10 mV peak to peak
Trigger types (digital inputs) MSO models only: Edge, pulse width, dropout, interval, logic, pattern, mixed signal
Maximum pre-trigger capture Up to 100% of capture size.
Maximum post-trigger delay Zero to 4 billion samples, settable in 1 sample steps (delay range on fastest timebase of 0 to 4 s in 1 ns steps)
Trigger rearm time
8-bit mode, typical: 1 μs on fastest timebase
8 to 12-bit modes: < 2 μs max on fastest timebase
14 to 16-bit modes: < 3 μs max on fastest timebase
Maximum trigger rate 10 000 waveforms in a 10 ms burst, 8-bit mode
External trigger input – not MSO models
Connector type Front panel BNC(f)
Trigger types Edge, pulse width, dropout, interval, logic
Input characteristics 1 MΩ ±1% || 14 pF ±1.5 pF
Bandwidth 60 MHz 100 MHz 200 MHz
Threshold range ±5 V
External trigger threshold accuracy ±1% of full scale
External trigger sensitivity 200 mV peak to peak
Coupling DC
Overvoltage protection ±100 V (DC + AC peak)
Function generator
Standard output signals Sine, square, triangle, DC voltage, ramp up, ramp down, sinc, Gaussian, half-sine
Pseudorandom output signals
White noise, selectable amplitude and offset within output voltage range.
Pseudorandom binary sequence (PRBS), selectable high and low levels within output voltage range, selectable bit rate up to 20 Mb/s
Standard signal frequency 0.025 Hz to 20 MHz
Sweep modes Up, down, dual with selectable start / stop frequencies and increments
Triggering
Can trigger a counted number of waveform cycles or frequency sweeps (from 1 to 1 billion) from the scope trigger, external trigger or from
software. Can also use the external trigger to gate the signal generator output.
Output frequency accuracy Oscilloscope timebase accuracy ± output frequency resolution
Output frequency resolution < 0.025 Hz
Output voltage range ±2 V
Output voltage adjustments Signal amplitude and offset adjustable in approx 0.25 mV steps within overall ±2 V range
Amplitude atness < 1.5 dB to 20 MHz, typical
DC accuracy ±1% of full scale