Datasheet

______________________________________________________________
_______________________________________________________________
9
4.4 OPERATION
To activate the unit, move the rotary switch from the OFF
position to the required measuring range. If the value of the
current being measured is unknown, first select the highest
range and then reduce accordingly.
4.5 BATTERY STATUS
Battery status is indicated by an orange LED on the front of the
integrator module. This LED will flash once when the unit is
switched ON. The length of time the LED is lit will increase as
battery life decreases. If the LED is continuously lit, the
batteries are low and need to be replaced.
Always use appropriate equipment for personal
protection. Do not use the flexible current probe
to measure bare conductors unless wearing
protective clothing suitable for high-voltage work.