User Manual

Product information6

2.5

Connection: Ethernet port

Setup utility

Before connecting to the USB PT-104's Ethernet port, you must first configure the

Ethernet settings. Proceed as follows:

1. Connect the unit to your computer using the USB port.

2. Run the Ethernet Settings utility. There is a shortcut to this utility in the Pico

Technology program group under the Windows Start menu.

3. Set the Device Types control to "PT-104 (USB)".

4. The serial number of your device should appear in the device list. Click the device

once to select it.

5. Set the Enable Ethernet Settings check box.

6. Enter the IP address and port that you wish to give the device. You may need to

ask your network manager for an IP address that does not conflict with existing

devices on the network.

7. Click Save and then Exit.

8. Power down the device by unplugging the USB cable.

9. Power up the device, either by connecting the USB port to a USB host, or by

connecting the Ethernet port to a Power-over-Ethernet power source. This causes

the USB PT-104 to update its configuration.

10. You can now either continue to use the USB PT-104 as a USB device, or unplug

the USB cable and reconnect the device using its Ethernet port.