Specifications

10
CONTACT US TOLL FREE 800-421-6511
www.picomacom.com
PICO MACOM
Owners Manual
PICO-PRO/Q
Edit User Plan
You can edit the parameter of the channel plan including channel name, select
or not, channel type, frequency, sound intermediate frequency of analog
channel and center frequency, bandwidth, QAM and symbol rate.
Type: Digi/Anal
BW: 1MHz – 9.9MHz
QAM: 16/32/64/ 28/256 QAM
SR: 1M – 7M
Choose the “Edit User Plan” icon in the setup mode. After pressing the Enter
Key, you can see the parameter setting screen. Select the channel by pressing
the Arrow Keys and enter setting state by the Enter Key (Fig. 10).
The “Select” and “Type” option can be changed by Left Key or Right Key, and
the other options can be edited by the Number Keys, saved by the Enter Key.
Select “save & return” and press the Enter Key to save.
Note: You can select “ALL” to change all the channels’ parameters instead of
changing them one by one.
Probe Compensation
Press the Enter Key to select “Probe Compensation” option (Fig. 11). Press
Left or Right Key to select the number to edit, and Up and Down Key to change
the number. Press the Enter Key to save.
Value Amendment (Calibration)
Every device has been tested before leaving the factory. Its frequency
response has gone through a very accurate calibration process and has been
saved in the memory. Some measurement deviations will probably appear due
to long-time use or component aging. This device enables the user to adjust
this measurement deviation. Using a calibrated signal source, the user may
calibrate the
Pico-Pro/Q to make its measurement results more accurate.
This function is also suitable for user’s special measurement requirements.
In the setup mode, select the “correct DB” icon and press the Enter Key to
start as shown in (Fig. 12). Under this situation, press F1 and F2 to adjust levels
and F3 to save. In addition, you can change the channel or frequency easily by
pressing Left Key and Right Key or the exact number and the CH or MHz Key.
When it’s in the frequency mode, the CH Key with the Left or Right Key will
make the device change to the channel number.
Limit Set-up
You can set the limits in this function as needed. Select the “Limit Setup” icon and press the Enter Key. The limit window
will be shown on the LCD. Choose the option to edit by pressing the Up and Down Keys and adjust the value using the
Left and Right Keys. Lastly, select “save & return” and press Enter Key to save.
Load Default (Reset to factory data)
If there are settings that are not ideal, you can reset the device with the factory data. In the setup mode, select the “Load
Default” icon and press the Enter Key. Then choose OK or Cancel with Left, Right and Enter Key in the confirmation
window.
System Information
It shows the serial number of the device in your hand.

Fig. 10
Fig. 11

Fig. 12
