User Manual

WPS500X User’s Guide Pico Technology
6 DO157-9
4. The parts of your WPS500X pressure transducer
Signal output
Use the BNC-to-BNC cable supplied to connect this to your
oscilloscope.
Front-panel controls
See Section 5.
USB charging port
For battery recharging only (no data connection). Connect
to any USB port on a computer or a 5 volt USB wall charger.
Inlet port
Connect the pressure hose here.
Bleed vent
When the bleed screw is opened, this vent allows fluid to
drain out of the measurement chamber.
Bleed button
Push to open the bleed vent. Some models have a screw
instead of a push-button.
Signal output
to oscilloscope
Bleed
button
Bleed
vent
Inlet
port
Front-panel controls
USB charging
port