User Manual

WPS600 User’s Guide Pico Technology
4 DO187-4
DO NOT use if you are not trained to work with hydraulic systems
Use of this transducer by unqualified persons may result in equipment damage or
serious personal injury.
DO NOT exceed maximum working pressure
To avoid injury, do not use the transducer with pressures above 600 bar.
DO NOT exceed maximum temperature
The lithium polymer (LiPo) battery inside the transducer can be damaged by
excessive heating. Do not store or operate the unit at temperatures above 60 °C
(140 °F).
DO NOT operate without covers
To avoid equipment damage and personal injury, do not operate this transducer
with the covers removed.
DO NOT operate in wet or damp conditions
To avoid incorrect readings and possible equipment damage, do not operate this
transducer in wet or damp conditions or submerge it in liquid. The transducer is
splash-resistant but not immersion-proof.
DO NOT operate in an explosive atmosphere
To avoid personal injury and fire hazard, do not operate this transducer in an
explosive atmosphere.
DO NOT operate the transducer if damaged
If you suspect that the transducer is damaged, have it inspected by qualified
service personnel. Do not attempt to dismantle or repair it yourself.
DO NOT use with damaged or modified pressure hoses
Use only pressure hoses that have been pressure-tested. Do not use them if they
have been disassembled, modified or damaged.
DO NOT use in long-term or permanent installations
The WPS600 is intended for immediate diagnostic purposes only. It should not, for
example, be connected to a vehicle as a monitoring system.