Brochure

Accessories
Active differential probes
Passive probes
Our range of oscilloscope accessories has been carefully chosen for use with PicoScope oscilloscopes.
Please refer to www.picotech.com for prices.
Current probes
Current probes offer a safe, cost-effective, simple and
accurate way to take current measurements. They enable
you to measure currents without breaking the electric circuit.
Current probes are designed with sensors that can be opened,
placed around the conductor and securely fastened to form a
loop around the conductor.
The Pico current probes shown here can be used with Pico
oscilloscopes and data loggers, as well as with all major
brands of oscilloscopes and multimeters.
• ± 5 g measurement range
• DC to 350 Hz frequency range
• Mounting magnet included
• 3 x BNC to BNC cables included
A wide range of 4 mm (banana plug)
cables, connectors, adaptors, clips and
probes are available, with CAT II and CAT
III ratings also available.
Attenuator set: BNC 50 Ω, 1 W, 1 GHz, 3,
6, 10, and 20 dB
The TA050 attenuator set consists of four
coaxial attenuators designed for use with
signals up to 1 GHz. Each attenuator has
a male and a female BNC connector.
Please refer to www.picotech.com for prices
Active differential probes extend
the functionality of standard single-
ended input oscilloscopes to allow
a safe and accurate method of
making high-voltage differential
measurements.
Applications include making safe
measurements in power circuit
applications and acquisition of low-
speed balanced differential signals
found in serial communications
buses.
Active single-ended probes
The TETRIS range is independent of any particular system and can
be plugged into any measuring instrument with a 50 Ω input. With an
input resistance of 1 MΩ and an input capacitance of just 0.9 pF, the
TETRIS probes are suitable for measurements in all frequency ranges.
Compared to passive probes the TETRIS active probes offer a high
input impedance into the GHz range. Three probes are available from
1 GHz to 2.5 GHz bandwidth.
TA062 passive probe (BNC)
TA061 passive probe (SMA)
These very high-bandwidth
1.5 GHz low-impedance
probes are suitable for
use with high-speed
oscilloscopes and spectrum
analyzers. Available with
either an SMA or a BNC
connector.
TA150 350 MHz passive probe
TA133 500 MHz passive probe
High-quality, high-impedance
BNC oscilloscope probes. Each
probe is supplied with a range
of accessories for convenient,
accurate measurements. Fixed
10:1 attenuation. Ideal for use
with the PicoScope 6000 series.
PicoConnect 900 Series
A family of high-performance
RF, microwave and pulse probes
allowing cost-effective ngertip
browsing of broadband signals
up to 5 GHz (10 Gb/s).
TA386 150 MHz passive probe
TA375 250 MHz passive probe
High-quality, high-impedance, BNC oscilloscope
probes. A two-position slide switch selects
attenuation of either 1:1 or 10:1.
Three-axis accelerometer
The PP877 is a three-axis MEMS accelerometer and oscilloscope
interface. It is supplied with three short BNC to BNC cables which
plug directly into any PicoScope oscilloscope with three or more
analog channels. High-resolution oscilloscopes such as the
PicoScope 4424 Series are recommended to take advantage of their
increased sensitivity.
Other probes and sensors
www.picotech.com