Instructions for use

VERTICAL INSTALLATION.
Top side.
Mark line.
1. Slide the rudder into the fuselage as same
as picture below.
2.Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
3.Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
Remove
covering
Vertical stabilizer installation
See picture below.
Rudder servo left side
17
JOKER XL Instruction Manual