Instructions for use

Viper Jet MKII Item code: BH175 Instruction Manual

1. The switch should be mounted on the fuselage

side, opposite the muffler, close enough to the

receiver so the lead will reach. Use the face plate

of the switch cut out and locate the mounting

holes.

2. Cut out the switch hole using a modeling knife.

Use a 2mm drill bit and drill out the two mounting

holes through the fuselage side.

3. Secure the switch in place using the two machine

screws provided with the radio system.

1. Plug the servo leads and the switch lead into the

receiver. You may want to plug an aileron

extension into the receiver to make plugging in the

aileron servo lead easier when you are installing

the wing. Plug the battery pack lead into the

switch.

2. Wrap the receiver and battery pack in the protective

foam to protect them from vibration. Use a rubber

band or masking tape to hold the foam in place.

Do not permanently secure the receiver and battery

until after balancing the model.

INSTALLING THE RECEIVER AND BATTERY

INSTALLING THE SWITCH

Top view

Assemble left and right

sides the same way.