Instructions for use

Viper Jet MKII Item code: BH175 Instruction Manual

Horn

2x40mm Push rod

- - 1

- - - - - - - 2

- - - - - - - 1

- - - - - - - 2

Aluminum ball

3mm Flat Washer

Bottom view

Horn

3mm Hex Nut

3 x 12mm Cap Screw

Cut off shaded portion

INSTALLATION THE VERTICAL STABILIZER LINKAGES

2x40mm

Aluminum ball

1. Install the control horn into the vertical stabilizer.

2. Locate the metal rod wire, screw the plastic link ball

onto the threaded end of the wire.

3. Plug the vertical stabilizer servo into the receiver and

center the servo. Install the servo arm onto the

servo. The servo arm should be perpendicular to the

servo and point toward the middle of the rudder.

4. Center the aileron and hold it in place using a

couple of pieces of masking tape. Adjust the

linkage until the vertical stabilizer and the servo

arm are both centered and then tighten the nut

against. Remember use thread locking

compound to secure.

5. Repeat step 1 - step 4 for the second vertical

stabilizer linkage.

Apply epoxy glue.