Instructions for use

Viper Jet MKII Item code: BH175 Instruction Manual

INSTALLING THE HORIZONTAL STABILIZER

LINKAGES

Horn

Bottom view

3x40mm Push rod

- - 2

- - - - - - - 4

- - - - - - - 2

- - - - - - - 4

Aluminum ball

3mm Flat Washer

Horn

3mm Hex Nut

3 x 12mm Cap Screw

3x40mm

Aluminum ball

Cut off shaded portion

Assemble left and right

sides the same way

Apply epoxy glue.

The number of times

the same way Assembly

(in this case twice).

1. Install the control horn into the horizontal stabilizer.

2. Locate the metal rod wire, screw the plastic link ball

onto the threaded end of the wire.

3. Plug the horizontal stabilizer servo into the receiver

and center the servo. Install the servo arm onto the

servo. The servo arm should be perpendicular to the

servo and point toward the middle of the horizontal

stabilizer.

4. Center the horizontal stabilizer and hold it in place

using a couple of pieces of masking tape. Adjust

the linkage until the horizontal stabilizer and the

servo arm are both centered and then tighten the

nut against. Remember use thread locking

compound to secure.

5. Repeat step 1 - step 4 for the second horizontal

stabilizer linkage.