Instructions for use

Viper Jet MKII Item code: BH175 Instruction Manual

Bottom view

INSTALLING THE HORIZONTAL STABILIZER SERVO

1. Install the rubber grommets and brass eyelets

onto the aileron servo.

4. Using the thread as a guide and using masking

tape, tape the servo lead to the end of the

thread: carefully pull the thread out. When you

have pulled the servo lead out, remove the

masking tape and the servo lead from the

thread.

5. Place the horizontal stabilizer servo tray / hatch

into the servo box on the bottom of the wing

and drill pilot holes through the tray and the

servo box for each of the four mounting

screws. Secure the servo tray in place using

the mounting screws provided.

2. Using a modeling knife, remove the covering

from over the pre-cut servo arm exit hole on the

horizontal stabilizer servo tray / hatch. This

hole will allow the servo arm to pass through

when installing the aileron pushrods.

3. Place the servo into the servo tray. Center the

servo within the tray and drill pilot holes

through the block of wood for each of the four

mounting screws provided with the servo.

Assemble left and right

sides the same way.

Must be purchased

separately!