Instructions for use

Attach the Horizontal Stabilizer
Incorrect
Correct
A
A’
A=A’
A
A’
A=A’
/
Check the alignment of the horizontal
stabilizer by measuring from a fixed point
along the center line of the fuselage to the
leading edge on each side of the horizontal
stabilizer. The distance must be equal on
both sides. If not, adjust the stabilizer until
the measurements are the same.
Securely glue together. If coming
off during flight, you lose control
of your air plane.
4x30mm nylon bolt
............1
Control horn
...........1
1A
TOP VIEW
Draufsicht
CA
CA
Thin CA
1.5mm
Using a pencil, mark on the leading edge of elevator,
where the hole is to be drilled.
Drill a 1.5mm hole of the mark made in Step 1D
Marking sure that you drill the hole
perpendicular to the leading edge
of the elevator half.
MARK
1
1B
1C
1D
1E
1F
Trial fit the elevator half in place, check the alignment
of the horizontal stabilizer and the elevator half.
Fuhren Sie die Verklebungen mit gro ter
Sorgfalt aus.