Instructions for use

FOCKE WULF Item code: BH178 Instruction Manual

INSTALLING THE RECEIVER AND BATTERY INSTALLING THE SWITCH

1. Plug the servo leads and the switch lead into the

receiver. You may want to plug an aileron extension

into the receiver to make plugging in the aileron

servo lead easier when you are installing the wing.

Plug the battery pack lead into the switch.

1. The switch should be mounted on the fuselage

side, opposite the muffler, close enough to the

receiver so the lead will reach. Use the face plate

of the switch cut out and locate the mounting holes.

2. Cut out the switch hole using a modeling knife.

Use a 2mm drill bit and drill out the two mounting

holes through the fuselage side.

3. Secure the switch in place using the two machine

screws provided with the radio system.

2. Wrap the receiver and battery pack in the protective

foam to protect them from vibration. Use a rubber

band or masking tape to hold the foam in place.

Do not permanently secure the receiver and battery

until after balancing the model.

Fuselage Top Side

Zip tie

Valve control servo

Air tank

- - - - - - - - - 1

- - - - - - - - - 2

3 x 12mm TP Screw