Instructions for use

1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
1.5mm
CA
Thin CA glue
Toothpick
HORIZONTAL STABILIZER
Elevator Safety.
Toothpick
(x 12pcs)
Petroleum jelly
Apply a thin layer of machine oil or
petroleum jelly to only the pivot point
and the leading edge of the elevator.
HORIZONTAL STABILIZER
A
B
When satisfied with the and alignment, hinge the elevator to the horizontal
stabilizer using 5 minute epoxy. Make sure to apply a thin layer of epoxy to
the top and bottom of both hinges and to inside the hinge slots. Repeat the previous
procedures to hinge the second elevator to the other side of the horizontal stabilizer.
5 minutes
A
B
Please do not clean off the excess epoxy on the horizontal stabilizer and
the elevator with strong solvent or pure alcohol, only use kerosene to keep
the colour of your model not fade.
Step 14A
Step 14B
Step 14D
Step 14C
Step 14E
Cut the excess toothpick and secure it
in place using little Thin CA glue.
NOTE: You may need to open up the slots
so that the hinges are not too difficult to
push in.
Not include
RARE BEAR
SECTION 14 - ELEVATOR
5 minutes
!
VERY IMPORTANT
If you not make this step, the elevator may be
comming off when your airplane flying with
high speed. You will lose control of your airplane.