Instructions for use

6
2x10mm Treibschraube
- - - - 8
Warning!
Servokabel an Schnur befestigen
Tie the string
Servokabel mit Schnur durchziehen
Pull out servo cord with string
1
2
ANSICHT VON UNTEN
BOTTOM VIEW
1
2
2x10mm Tp Screw
Querruder Aileron
QUERRUDER ANLENKUNGEN / AILERON LINKAGES
1. Schrauben Sie einen Nylon-Gabelkopf auf die Schubstange (ca. 14 Umdre
hungen). / Working with the aileron linkage for now, thread one nylon clevis at
least 14 turns onto one of the 2mm threaded wires.
4. Querruder mit Tape in der Neutralstellung fxieren. / Center the aileron and
hold it in place using a couple of pieces of masking tape.
5. Markieren Sie den Punkt auf dem Gestänge, der sich über dem Loch des Ser-
vorams bendet. / With the aileron and aileron servo centered, carefully place a ma-
rk on the aileron pushrod wire where it crosses the hole in the servo arm.
6. Versehen Sie das Gestänge an der Markierung mit einer 90° Biegung. Schneiden
Sie den überschüssigen Draht ab, so dass nach der Biegung ca. 6 mm übrig bleiben. /
Using pliers, carefully make a 90 degree bend down at the mark made. Cut o the ex-
cess wire, leaving about 6mm beyond the bend.
7. Stecken Sie das Gestänge in den Servoarm und sichern Sie es mit einer Nylon-
Sicherung, wie dargestellt. Abschließend das Tape von den Querrudern entfernen. /
Insert the 90 degree bend down through the hole in the servo arm. lnstall one nylon
snap keeper over the wire to secure it to the arm. lnstall the servo arm retaining screw
and remove the masking tape from the aileron.
8. Wiederholen Sie den Vorgang auf der anderen Seite. / Repeat steps to install the
second aileron servo in the opposite wing half.
2. Entfernen Sie die drei überüssigen Servoarme und bohren Sie das dritte
Loch von innen auf ø2,0 mm auf. / Locate one nylon servo arm, and using wire
cutters, remove all but one of the arms. Using a 2mm drill bit, enlarge the third
hole out from the center of the arm to accommodate the aileron pushrod wire.
3. Querruderservo anschließen und Neutralstellung ermitteln. Der Servoarm
muss dabei im 90° Winkel zur Längsachse stehen. / Plug the aileron servo into
the receiver and center the servo. lnstall the servo arm onto the servo. The servo
arm should be perpendicular to the servo and point toward the middle of the wing.
BA
Ruderhorn
2
100mm Schubstange
- - 2
Nylon Clevis
- - - - - - - 2
Ruderhorn
1.7x8 mm Cap Screw
- - - - - - 2
- - - - - - 2
- - - - - - - 2
Sicherung
ANSICHT VON UNTEN
BOTTOM VIEW
9
Manual Supra Fly.indd 9 19.03.18 11:00
Mit Epoxydharz verkleben!
Use Epoxy Glue!
Eine linke und eine rechte Seite bauen!
Build a left and a right side!
Markierte Fläche abschneiden!
Cut the marked area!
Vorgang x-mal wiederholen.
Repeat this step.