Instructions for use

-Using a aluminum motor mounting plate as a
template, mark the plywood motor mounting plate
where the four holes are to be drilled.
-Remove the aluminum motor mounting plate and
drill a 1/8”(3mm) hole through the plywood at each
of the four marks marked .
Note: The aluminum motor mounting included with
electric motor set.
3mm
- Remove the plywood motor mounting and drill a
6mm holes through the beam at each of the
four marks made above.
6x100mm..........4
6mm nut.........12
6mm washer...16
6mm
! Align the mark on plywood motor mounting
with the mark on the fire-wall.
! Align the mark on plywood motor mounting
with the mark on the fire-wall.
ZLIN Z-526
14- Electric motor