User's Manual
6
Skyhawk Trapmate Mini Installation:
The Skyhawk Trapmate Mini can be installed using three main methods that include using the supplied 3M dual-
lock strips, using the self-stick magnets to attach to a magnetic surface, or by using rubber feet.
Method 1 : 3M Dual-Lock Strips
Step 1: In the accessory kit locate the two sets of 3M dual-lock strips. Keep these strips together and do not
separate them at this time!
Step 2: Clean the rear surface of the Skyhawk Trapmate Mini for proper bonding of the strips.
Step 3: Peel one side only of each set of strips to expose the adhesive and ax to the rear of the unit.
Step 4: Make sure the area of where the Skyhawk Trapmate Mini will be attached has a clean surface for proper
bonding of the strips. Do not separate the strips from the back of the unit at this time!
Step 5: Peel the remaining side of each of the strips to expose the adhesive and position it on the object and press
down on the whole Skyhawk Trapmate Mini unit. Do not remove the Skyhawk Trapmate Mini at this time - give
the 3M dual-lock adhesive about 30-minutes to bond.
Attach
to
Object