User's Manual
Hub Installation:
The Hub can be installed using various methods including, but not limited to, dual-lock strips, magnets or rubber
feet. Some of these mounting accessories may be included with the Hub accessory kit.
Method 1 : Dual-Lock Strips (if included)
Step 1: In the accessory kit, locate the two sets of dual-lock strips. Keep these strips together and do not separate
them at this time!
Step 2: Clean the rear surface of the Hub with 70% isopropyl alcohol for proper bonding of the strips.
Step 3: Peel one side only of each set of strips to expose the adhesive and ax to the rear of the unit.
Step 4: Make sure the area where the Hub will be attached has a clean surface for proper bonding of the strips. Do
not separate the strips from the back of the unit at this time!
Step 5: Peel the remaining side of each of the strips to expose the adhesive and position it on the object and press
down on the whole Hub. Do not remove the Hub at this time - give the dual-lock adhesive about 30-minutes to
bond.
Attach
to
Object
6