User's Manual

The Hub comes with three AA 1.5 volt lithium batteries already installed but in time these will need to be replaced.
When they are replaced it is suggested to use a high quality name brand AA lithium battery like an Energizer
Advanced Lithium or Ultimate Lithium battery. Follow the instructions below to replace these batteries.
Hub Battery Replacement:
Step 1: Remove the cover screws of the Hub using a Phillips screwdriver. Make sure to turn the screws
counterclockwise.
Step 2: Open the cover by tilting the cover’s front up toward the rear to prevent damage to the overlay connection.
If connection becomes loose it can be reseated. There will be a gasket holding the unit together so it might take a
bit of force to separate the cover from the enclosure.
Top to bottom
overlay connection
12