Operation Manual

FAILED IGNITION: WHAT TO DO
Action Description Display
Shut the stove down
by pressing the
ON/OFF key down for
a few seconds
CLEANING
BRAZIER
1 2:0022
.
c
1
• The warning buzzer stops.
• The readout CLEANING GRATE appears on the display and when the
stove has cooled the readout OFF appears.
• Check the cause of failed ignition and why the safety device has
activated. Always remove any fuel from the grate before starting a new
ignition process.
1
CLEANING
GRATE
1 2:00 73F
Restart the stove by
pressing the ON/OFF
key
CLEANING
BRAZIER
1 2:0022
.
c
1
• Repeat the ignition process as described above.
a If the stove occasionally fails to ignite it could be caused by:
- pellet composition or size not in compliance with the specications given in this booklet (see the “FUEL” section);
- insufcient mains voltage, whether in the form of intermittent voltage drops or a constantly lower value.
In the above cases any call-out of the service centre is not covered by the warranty, since the problem is not due to a defect in the
product.
DT2040057-07
WAIT FOR START UP
Action Description Display
The user attempts
to restart the stove
during the shutdown
stage when the
stove is still hot by
pressing the ON/
OFF key for a few
moments
WAIT FOR
S TART UP
1 2:0073F
1
If the readout “WAIT FOR START UP” appears on the display by pressing
the ON/OFF key for a few moments, it means that the stove is still hot and
it is necessary to wait for it to cool.
The new ignition cycle will be inhibited until the stove ends the cooling
phase.
After waiting for a few minutes the user can restart the stove and a new
ignition cycle will start automatically from the control stage.
WAIT FOR
S TART UP
1 2:0073F
1
DT2040123-00
H07032120 / DT2002308 – 00
34
English