Operation Manual

This conguration will help prevent blockage of vent by snow drifts. Also
the minimum vertical run of 5 feet (1,5 m) ensures the ventilation of the
exhaust in the event of a power failure, and allow for easier cleaning
through cleanout on tee.
a Certain local code restrictions may apply. Check with Local
Ofcials rst before installing.
a Strictly observe the PL Vent manufacturer’s safety
specications when using wall pass through.
a INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT
MANUFACTURER.
a Double wall PL vent requires a minimum clearance to
combustibles according to the manufacturer’s safety
specications and the use of listed wall thimble, re stop or
roof ashing where applicable.
a Do not place joints within wall pass-throughs.
a Ensure that all installation work is carried out to professional
standards.
Horizontal installations that terminate without any vertical sections of
pipe are approved; however, it is recommended that a minimum of 5’
(1.5 m) of vertical be included in the vent system. Having a vertical
section in the venting will help prevent smoke from exiting the appliance
during power failures.
It is required that outside air be installed with this venting conguration
to reduce smoke and creosote smell in the room in the event of power
failure.
a This Installation may cause problems during adverse weather
or power failure.
a We strongly recommend using a battery backup system if the
stove is installed using horizontal venting only. This prevents
any smoke from entering your home in the event of a power
failure.
a Certain local code restrictions may apply. Check with Local
Ofcials rst before installing.
a Strictly observe the PL Vent manufacturer’s safety
specications when using wall pass through.
a INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT
MANUFACTURER.
a Double wall PL vent requires a minimum clearance to
combustibles according to the manufacturer’s safety
specications and the use of listed wall thimble, re stop or
roof ashing where applicable.
a Do not place joints within wall pass-throughs.
a Ensure that all installation work is carried out to professional
standards.
1.12 MINIMUM FLUE VENT CONFIGURATION
45° ELBOW
18"
12"
OUTSIDE
AIR SHIELD
VENT
OUTSIDE
AIR PIPE
Fig. 18
H07032120 / DT2002308 – 00
13
English
DT2034497-01