Installation Guide

5 6
Faucet Installation Steps
1.Before installation, make sure there are three holes (φ1.3")on the table
top.Refer to draft (A).
2.Take off the fixing screw,s/s waving plate and plastic plate (except the
rubber ring),and put the inlet pipe go throught the hole.Refer to draft (B)
3.Assemble the plastic plate, s/s waving plate and fixing screw to the
tube,put the faucet body on the table top, and install fast conntection
rubber tube and flexible hose.Refer to draft (C)
4.Connect the angle valve and tighten it by wrench.Close the switch of
faucet and open the switch of angle valve,keep pressure for 30 minutes, to
check if it leaks at all connections. Refer to draft (D).
Instructions
Turn the left handle anticlockwise to open the hot water. The larger the angle is,
the larger the flow is. Reset is closed. Turn the right handle clockwise to open the
cold water. The larger the angle is, the larger the flow is. Reset is closed.
Low Regulator Replacement
Remove the aerator collar, replace the aerator core, reinstallation can
be completed.
This faucet ships with a 1.2 GPM flow restrictor installed. An optional 1.5
GPM flow restrictor is also included in the box.
To switch the flow rate of the faucet:
Care & Maintenance
1.Rinse with clean water & dry with a soft cloth
To keep the product clean & shining, follow the steps below:
2.Do not clean with soaps, acid, polish, abrasives or harsh cleaners
3.Do not use cloth with a coarse surface
4.Unscrew the aerator and clean when necessary
A
B
C D
1.3"1.3"
4"4"
8"8"
Replace