User's Manual

1. Physilog 6S elements

2. Charging

The Physilog 6S is charged via the USB-C port. Plug the USB-C connector of the cable delivered

with the Physilog 6S to the sensor. Plug the USB connector to a Computer or charger (see voltage

specifications below). Physilog 6S recording must be stopped for charging. Do not charge

Physilog® when room temperature is outside of range 0°C to 30°C.

Low battery level is indicated by yellow LED during measurement or if the Physilog® blinks

rapidly 3 times red when starting and doesn't start the recording (see LED indications below). A

battery level estimation is available via the Gait Up mobile applications. When the Physilog® is

discharged, plug it for charging for at least 30 minutes before use.

It is recommended to avoid complete discharging of the Physilog 6S, therefore check that the

Physilog® sensors are off when you store them. After a long period without using the Physilog®,

plug it for charging for at least 30 minutes before use. If the device is not used for a time period

Physilog 6S V1.1B user manual v0.0.2 Date: 08.12.2021